CONDOR BEAK Without Cut [STEEL]
Out of stock
Only %1 left
SKU
013851 CONDOR BEAK Without Cut [STEEL]
CONDOR BEAK With Cut [STEEL] (Inquiry-needed)
This item is not compatible with [2BA] or Swiss Point barrels.
We don't have this item in stock.
Must confirm the supply status with the manufacturer before order.
After confirming, the item usually takes more than 2-4 weeks to prepare.
If you would like to order this item, please contact us viaoffice@aadarts.com (our customer service E-mail).
For better management, please refrain from using other customer service channels for order inquiries.
Thank you for your understanding.
Focused on a shape that is easy to stick and hard to fall off.
Rust-resistant and highly durable special alloy is used.
A ring cut with a firm edge is applied.
Complies with the new DRA rule that will come into force starting in the 2024 season.
The roughness of the surface of the point is within 15mm from the tip which is within regulation of the new DRA rule.
Darts boards are also less likely to be damaged.
Designed with a wire diameter of 2.34mm, which was tested in 0.01mm increments that fitted the most number of barrels.
Tolerence of ±0.01mm is achieved by Japanese technology.
A guide line of 1mm pitch is provided for easy length alignment during barrel press fitting.
This item is not compatible with [2BA] or Swiss Point barrels.
We don't have this item in stock.
Must confirm the supply status with the manufacturer before order.
After confirming, the item usually takes more than 2-4 weeks to prepare.
If you would like to order this item, please contact us viaoffice@aadarts.com (our customer service E-mail).
For better management, please refrain from using other customer service channels for order inquiries.
Thank you for your understanding.
Focused on a shape that is easy to stick and hard to fall off.
Rust-resistant and highly durable special alloy is used.
A ring cut with a firm edge is applied.
Complies with the new DRA rule that will come into force starting in the 2024 season.
The roughness of the surface of the point is within 15mm from the tip which is within regulation of the new DRA rule.
Darts boards are also less likely to be damaged.
Designed with a wire diameter of 2.34mm, which was tested in 0.01mm increments that fitted the most number of barrels.
Tolerence of ±0.01mm is achieved by Japanese technology.
A guide line of 1mm pitch is provided for easy length alignment during barrel press fitting.
